Tap-End Stud

Manufacturing Scope

Tap-End Stud is a Fasteners family precision-turned on a Goodway SW-20, covering 10 variants — diameters ⌀5–12 mm, lengths 43–138 mm, standard material Steel (also steel, stainless, brass or aluminium). Every variant's part code, dimension and tolerance is listed below; request an instant quote with the code you need.

The family is machined from ⌀12 mm bar stock; its longest variant is BAGB-TES-10 at 138 mm. Besides turning, the family requires thread turning (5 sizes from M5 to M12). All of it is completed in a single setup, without the part leaving the machine.

The most slender variant is BAGB-TES-04: 73 mm long at ⌀6 mm, a length-to-diameter ratio of 12.2. This ratio is the very reason sliding-head lathes exist. The guide bushing supports the bar immediately beside the cutting point, so there is no deflection; the same part chatters and drifts in diameter on a conventional lathe.

Variants are machined to 6g tolerance; the smallest is BAGB-TES-01 (⌀5 mm) and the largest BAGB-TES-10 (⌀12 mm). The family includes threaded, multi-step variants. Custom sizes, tolerances or materials are produced to the part code on request.